If you would like to monitor through MainStage directly for whatever reason, you can assign an output device as well. The “Monitors” section is blank because we can monitor through Logic Pro X. Set up an eight-channel virtual audio device with Loopback. Next, add eight output channels, and connect each channel to the corresponding channel of the “Pass-Thru” source. To do this, simply create a new device in Loopback and add a “Pass-Thru” device in the “Sources” section. In this example, we’re going to set up an eight-channel virtual device in Loopback to pass eight channels of audio from MainStage into Logic Pro X. With Loopback’s built-in routing modules and mixer, you can create complex internal connections without touching a single cable. Loopback allows you to create a virtual audio device to pass audio between applications. I’m a huge fan of their products – especially Loopback and Audio Hijack. Loopback is a “cable-free audio routing” app from the awesome folks at Rogue Amoeba. In this post, you’ll learn how to record multitrack audio from MainStage to Logic Pro X with Loopback. It’s technically possible to use either S/PDIF or ADAT for this kind of recording setup, but it’s much simpler to route audio in software – no cables and higher channel counts. If you want to run MainStage and record to Logic Pro X on the same computer with no quality loss, you’ll need a digital audio router of some sort. While MainStage has built-in recording capabilities, tracking to a proper DAW like Logic Pro X provides much more flexibility.
0 Comments
Leave a Reply. |